Heat Resistant Waterproof Tile Adhesive Tile Gum For Outdoor
PB-01 General Tile Glue
White, gray power
Strong cohesion force, low stress, low dilatability, no bubble, anti-aging, proper
viscosity and easy to operate
Applied to indoor and outdoor wall paste of large-scale ceramic
tile, grassing stone, natural stone material
Smooth and firm, no dust, grease, release agents, batik material,
PB-01 General Tile Glue is a new type strong adhesive, applied to
indoor and outdoor wall paste of large-scale ceramic tile, grassing
stone, natural stone material, modifies epoxy glue with features of
strong adhesive strength, low stress, low dilatability, no bubble,
quick set, proper viscosity and easy operate, resistant of grind,
aging, cold-hot exchange.
1. Has strong cohesion force. Reduce the common phenomenon of tiles
detaching and peeling when pasted by Portland cement.
2. Be premixed and produced, the product is stable, water and used,
to protect the construction environment.
3. Has strong water retention, no need to DIP tiles and wet walls,
thin construction, easy operation, to reduce material consumption
and building load.
4. Has good flexibility to resist effectively the destruction of
5. Has special formula to avoid completely the common phenomenon of
tiles cracking, detaching and peeling by Portland cement.
6. It is no-toxic, no-radiation, no smell and environmental.
7. Has special formula to prevent the flow with too much southbound
crash, easier construction.
Treatment of base plane:
1. Base plane should be smooth and firm, no dust, grease, release
agents, batik material, etc.
2. Check base plane roughness by 2m guiding rule, error should be
less than 5mm.
3. New plastering cement mortar could be constructed after 14 days
1. Construction tools: Leveling instrument, dentiform drawknife
(3×3mm, 4×4mm, 6×6mm, 8× 8mm, 10×10mm), tile generator, motor
stirrer, big drum, cross-colloidal.
2. Stir and mix: Mix tile adhesive and water as 20: (5~6.5) stirs
completely and waiting for 5 minutes, stir again.
3. Layup construction: Scrape the glue paste evenly on base plane
with dentiform drawknife, the area should be about 1 m ² each time,
then knead and press on the base plane. The model of the dentiform
drawknife depends on the size of the tiles.
1. The vertical and smoothness of the substrate must be confirmed
2. The product is suitable for construction in the 5℃~40℃.
3. Don't use the dried paste by reading water.
4. If the base plane is uneven or the back of tile is not smooth,
wiping the paste on the back of brick in order to ensure it full
with paste to avoid hollowing.
Original tensile adhesive strength(Mpa)
Tensile adhesive strength after water(Mpa)
Tensile adhesive strength after thermal aging(Mpa)
Tensile adhesive strength after thawing cycle(Mpa)
Tensile adhesive strength after standing for 20 min(Mpa)
Store in cool and dry place, unopened product can be saved for one